Brookstone i-Convert User Manual download pdf (Page 6)

CALIBRATING THE SCANNER

1. Turn the Scanner on by sliding the POWER switch.

2. Place the Scanner on the White Balance Calibration Sheet.

3. Press and hold the STITCH button. While holding the STITCH button,

press the SCAN button once and then release both to enter into auto-

calibration mode. The microSD CARD INDICATOR will flash.

4. The green and red LED light will then turn on. Do not move the Scanner

until the red LED light turns off. The green LED will remain lit.

5. Start rolling the Scanner over the White Balance Calibration Sheet slowly

and evenly until the green light turns off (you may have to roll the Scanner

backwards if necessary).

6. When the green LED light turns off, the calibration is complete.

Slide the POWER switch to turn the Scanner off.

SETTING THE RESOLUTION

1. Turn the Scanner on by sliding the POWER switch.

2. By pressing the DPI button on the Scanner, you may choose between

high resolution (600 dpi) and low resolution (300 dpi).

3. The high or low resolution mode will be displayed on the LCD screen

to reflect your choice.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Brookstone i-Convert User Manual Page 6